What are system tasks?

Password Safe supports administrators and users by automating repetitive tasks. These are represented as system tasks. Predefined tasks can thus be carried out at freely defined intervals.

What can be automated?

There are currently four different work processes that can be automated using system tasks:

  • HTML WebViewer export: Exports a freely definable selection of records in an AES-256 encrypted HTML file. The file is saved in the form of notifications.
  • Reports: Automatically creates a report that is issued in the notifications. This requires a report request to be created in advance.
  • Network service scan: Searches for service accounts on the network at defined cycles
  • Active Directory synchronization: The comparison with the active directory can also be automated via system tasks. This requires an active directory profile to be created in advance. It is important to note that only the Masterkey profile can be automatically compared.


There is a separate user right for each of the four listed use cases:

Creating system tasks

System tasks can be initiated as usual via the ribbon or also the context menu that is accessed using the right mouse button. The desired process to be automated using system tasks is then selected from the four above-mentioned work processes.

Naturally, the four work processes also share some similarities in their configuration.

  • Status: The system task is normally activated and then starts immediately after it has been saved according to the defined intervals. If the system task is deactivated here, it is still saved but is not yet activated.
  • Next run: This setting describes when the system task will be performed or when it was already performed for the first time (if this task was already created and is now being edited)
  • Interval: The interval at which the system task should run is defined here. All increments between every minute and once only are possible. It is also possible to enter an end date.

The differences between the four work processes to be automated are described below. These differences are always part of the task settings within the system task form – the example here shows an HTML WebViewer export to be configured.

HTML WebViewer

  • Filter: The passwords that should be exported are defined using a filter.
  • Password: The HTML WebViewer creates an encrypted HTML file. The password is defined here and must then be confirmed.


  • Report request: The report requests defined in Reports are available and can be selected here.

Service scan

  • Service scan task: The password for this service is assigned as part of a Password Reset.

Active Directory synchronization

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.